Mopar Muscle Association UK

Hi,

Does anyone know of any stockists in the UK for Eastwood Calyx Manifold Dressing?

Have googled etc, but doesnt seem to be any listed, same with Amazon and Ebay.

Thought Frosts might have it, but also no joy.

Welcome to the forum, and always great to see another Duster here

Hi,

Is Roger still doing engines?

If he is, can anyone pm me contact (website/phone) details, as I did a search on here and only found the number (ending 328) which does not seem to be active.

Many thanks

Good info there Dave, very much appreciated

Robinson Racing recently did mine

For those in/near Hampshire, Bedfordshire and Warwickshire.....

https://caffeineandmachine.com/

Hi,

We have a '72 Charger with a Fibreglass Hood, held down with pins and no hinges.

Might be looking to add a steel hood at some point in future if one comes up....

Have been offered some hinges, but the seller is not sure on fitment and we havent any to compare.

Please can anyone advise if ...

McGard ones are the best quality and guaranteed for life against rust

Hi Jon,

Where are you based? as I have some wheels with 295/50/15 and 275/60/15's that are off my A body at mo, that you could try for mock up, but will depend on location and what backspace you may need etc

Thank you Mick,much appreciated

Sorry to revive this very old thread, but....

I have acquired an unused one of Trev's Ali Thermostat Housings (360 Magnum) and just need to know whether it uses the Standard Gasket Oval Gasket with the Bolt Holes or a Rubber O Ring?

Unfortunately, the TD Engineering website link listed above seems ...

On Amazon UK, when ordering / paying, make sure the section under the price shows the following to qualify:

Dispatches from Amazon US
Sold by Amazon US
Customer service Amazon

newsatten wrote: Sun May 25, 25 7:21 pm Need to buy a better quality hole cutter ,
My Chinese crap ones just melted when I tried to cut the drain hole !
Marvellous

Check out QMax sheet metal hole punches. More expensive than blade type, but clean cut and last much longer.

Excellent work on this thread

What did you use to gt the rust off the steering box, and will you put a finish on it?

How about a single handle hacksaw blade holder? Something like Screwfix code 188TF, or cheaper 1046X

Not sure if its possible to grind down the blade to a sharp edge so no teeth to damage anything, so it would be like a long stanly blade with a handle... As mygasser said, all depends how compressed ...