Just got back from US and found this in my suitcase ! Result ! Appears to be the new 'sniper2' with dizzy and coil and loom and automatic timing blah blah blah. I'm not a purist.
Guess my winter project is sorted then...
It'll be a slow burn thread but I will keep it updated
Holley Sniper
Moderator: Moderators
Holley Sniper
- Attachments
-
- IMG_9734.JPG (73.62 KiB) Viewed 8906 times
-
- IMG_9741.JPG (60.16 KiB) Viewed 8906 times
"Cum homine de cane debeo congredi." Woof.
Current Charger status - "Working !"
Current Charger status - "Working !"
Re: Holley Sniper
Nice
get it on there
Dave
get it on there
Dave
The Greater Knapweed near the Mugwort by the Buckthorn tree is dying
Re: Holley Sniper
Contemplating this as well, so I am keen to see how you get on.
Matt Hollingsworth - Vehicle Registrar
Panther Pink 73 Aussie Charger 265 Hemi 4 spd
Challenger Sam Posey Tribute car
Panther Pink 73 Aussie Charger 265 Hemi 4 spd
Challenger Sam Posey Tribute car
Re: Holley Sniper
Got it on the mustang 347 stroker runs sweet, when wiring in lots of the wiring needs to be cut and shut to keep it tidy or just tie wrap it up and hide the excess, also if you run a e/fan you can wire it in and set it via ecu programme
IF ITS ON WHEELS, LOWER IT!!
Re: Holley Sniper
I was just going to go the sniper route - but decided that I might as well have it do the timing as well - so I got the dizzy and the electronics which will play nice with the injection. Mt current timing is fixed due to lack of vacuum so this should play nicer.
We'll see. There are a LOT of boxes...
Will have a 12V MSD all-in-one setup for sale at the end... get rid of that ballast resistor folks !
We'll see. There are a LOT of boxes...
Will have a 12V MSD all-in-one setup for sale at the end... get rid of that ballast resistor folks !
"Cum homine de cane debeo congredi." Woof.
Current Charger status - "Working !"
Current Charger status - "Working !"