exhaust manifold"s

[sticky]

Looking for stock exhaust manifolds, a pair, or just a left side one, to fit a 318cu ins block. left side one has exit pipe to the rear. mine is LHD but i think they are all the same. thanks
STICKY

[sticky]

sorry, that should read right hand drive

[sticky]

found out a bit more info. Casting number is 2465719, and its the same for 273,318,340 and 360 cu ins engines

[aussie pete]

Hi, I’ve got some original cast iron ones from 318 Aussie Charger (I believe they are the same) and if your location is correct, you are local!
I’m not sure what you mean about the LH one having the exit to the rear.
The LH one ( on RH drive cars) has the manifold heat crossover valve fitted which puts hot air through the inlet manifold until it gets up to working temperature

[sticky]

Hi, my manifold does not have the manifold heat crossover valve, its on a 1969 RHD barracuda, but i will do a bit more digging and let you know. Thanks for your help.

[aussie pete]

A commmon mod that was done to delete the crossover valve was to fit two RH manifolds as they are the same castings.

[sticky]

Hi Pete, OK, the reason i was after an exhaust manifold was that mine got damaged during some work being done in a garage, and a repair was expensive. My son, who works in the transport industry, and for a company recently taken over by an american company, found one , in illanois, and had it sent back here. The amazing thing is, its BRAND NEW!!. So thanks for your offer of help, I just hope this is the end of the problem.

Sticky

[aussie pete]

good result