Page 4 of 16
Posted: Sat Aug 18, 07 12:24 pm
by Ivor
Check out Edgeware Motor Accessories too, they helped me out with some old profiles I couldn't find in the States.
Posted: Mon Aug 20, 07 8:57 am
by Dave999
i got a brand new Made in GB screen fitted last year
the fitter came with a new rubber but did not use it
i'll dig out the recipte to see who it was
£50 excess on my classic insurance and doesn't affect premium
Dave
Posted: Mon Aug 20, 07 9:20 am
by Dave999
exactly
the dodgey geez stole me new rubber
and
where the hell does anyone get a brand new laminated front screen with all the pilkington British standard blerb on it for a car that was not at all popular here
Tres odddddddddddddddddddd
Dave
Posted: Mon Aug 20, 07 10:25 am
by Dave999
No sir you miss my point
brand new
as in made last week brand new
not New old stock
brand spanking diddly new..... with green plastic stuck to it proper laminated not crack ya skull toughend circa 1960-1990
what the........... dave says out loud, and everyone turns round, must stop talking to myself.
yeah well-odd i know
Dave
Posted: Mon Aug 20, 07 3:28 pm
by Anonymous
Not as odd as how mch Mr. Nineninenine looks like David Gray in his Avtar.
Posted: Mon Aug 20, 07 4:12 pm
by Trigger_Andy
Clivey wrote:Not as odd as how mch Mr. Nineninenine looks like David Gray in his Avtar.
You mean to say he's not??? I thought all his rambling's was practice for his new songs.
Posted: Mon Aug 20, 07 5:06 pm
by Dave999
My name is David Gray
no joke of lie
find me on facebook
or ebay
and i give you a shiny coin
how you know my name??????
and i have a wobbly heed
Mr Bratby can confirm
I have mailed him in the near past from my place of toil
I serve the nations dreams each week day between 9 and 17:30
Dave
Posted: Tue Aug 21, 07 6:47 pm
by Scooby
Dave.
Nice motor as I said earlier, also good to meet you 2day ..name to a face and all that...
Good luck with your bits, will give you the heads up next time I venture up to Krispys...
Rich
Posted: Wed Aug 22, 07 9:00 am
by Dave999
yes indeed didn't realise you were so close.. wended my way through the lanes from the roundabout near J 17 only took about 15 mins
i will have to get myself across croydon way once i get this carb and maniofld back on
Dave
Posted: Thu Aug 23, 07 10:22 am
by Dave999
Gadzekes
when is a 10mm drill not a ten mm drill?
when its 10.2 mm drill for some unknown reason, measured it with me micrometer wrong wrong wrong says 10 on the shaft so it should be 10
10.2mm hole and a M10 tap do not mate in the correct manner
sausage down a bleeding tunnel
work will now stop until we purchase another chunk of purest steel.
OOOOOOOoooooooooooooooanoyance
Dave
Posted: Thu Aug 23, 07 10:36 am
by latil
Scroll down this page,you need a smaller drill
http://www.threadtools.co.uk/taptech.htm