Page 1 of 1
Trans cooler fittings
Posted: Mon Aug 15, 05 2:34 pm
by Jon
I'm going to plumb the original trans cooler on my car in line with the aftermarket one thats on now for a little extra cooling, the fittings on the rad are missing. does anyone know off the top of their head what thread they are
its a 26" rad in a 69 charger
Posted: Mon Aug 15, 05 4:47 pm
by Anonymous
I should have them here Jon will check and let you know
Posted: Mon Aug 15, 05 5:40 pm
by Jon
cheers
Posted: Mon Aug 15, 05 6:30 pm
by Anonymous
They should be 1/4 npt Jon now i only have these in a 90* with -06 AN on the other end, this would connect to -06 braided fittings
let me know if they are any use to you
Posted: Mon Aug 15, 05 6:30 pm
by Blue
If you mean the thread into the rad it's 1/8" NPT.
Posted: Mon Aug 15, 05 6:38 pm
by Anonymous
I just quoted the size out of my catalogue so must be a misprint, either way i got em in a 90* elbow if they are any use
Posted: Mon Aug 15, 05 6:45 pm
by Trigger_Andy
I can get any sized npt fittings in stainless and other more exotic materials for you guys for free!! Cross overs, elbows, tee pieces ect. Just let me know what you require and ill grab some when im next off-shore. 5-10,000 psi rated too!!
Posted: Mon Aug 15, 05 6:50 pm
by Anonymous
Figured out what are 1/4, it's the aftermarket coolers from the same place as my catalogue, DOH
