replied here
Ah its a VE not a VG sorry either way all the same
need axle bearings for a VC-VG yours in the the middle
viewtopic.php?f=22&t=60280
you put your orginal post or somone acceindtally moved it to the for sale parts section
But as hinted at in my long ramble
you could try a morgan dealer they used an M76 which is much the same as the M75 diff you have
these will probably fit
https://mogparts.net/search?query=BTR
you would need bearings and seal
i'd be requesting these on a return if they don't look like they will fit situation. 106A is the bearing set 106B sounds like the press on collar to hold the bearing on and 118B is the seal
However these MORGAN chaps really do take advantage of the fact that they think they are the only source of this kinda stuff... i.e they allways "see you coming"
otherwise these geezers might be able to do it for you
http://www.techniques.uk.com/morgan-ser ... e-rebuilds
given that your axle was made 66- 71 By Borg warner Austrlia and these mrogan axles were made in the 90s by British Tyre and Rubber, same factory differnt cheif... BTR took over the factory, went bankrupt and then were administerd by Grant Thornton until sale of the whole lot to spicer Axle Australia in the early 2000s you may find some ingenuity is necessary with the seals.
or US automotive who used to have a list of aussie compatible parts
best bet howeere is the four piece kit, you need two per axle, from an Aussie Supplier
OR try tech support at motospecs Sydney I used to annoy an old fella there regualarly asking questions about parts swapping between holdens fords and chryslers.
https://gpcasiapac.com/our-businesses/a ... motospecs/
ask for part numbers for bearing seal and bearing retianer collar for a 66-71 "Borg warner made" M75 axle from a VE valiant.
explain that you are in the UK so can't just Mailorder from a local aussie supplier, you need the detail.....
if they can give you the TOYO or torrington or SKF numbers for bearing retainer and seal
A local UK supplier can probably come up with the goods
if you have success this way post up the part numbers and we'll save them for the next guy....
another source would be any US car buisness in the Uk that specialises in 1982-1992 IROC-Z camaros and TA firebirds
they used the M76 axle as well, they called it a GM 9 bolt. the GM9 bolt had disk brakes and a different axleretainer so the seals may not work. but if you just need bearings you should be ok.
these people in the US do stuff under the GM 9 bolt banner, but i don't see wheel bearings
https://www.ratechmfg.com/gmstandard.htm
Handy for rebuild stuff cheaper than Oz and decent quality
however this is a bargain, told you the morgan guys saw you coming £66 AUD per kit rather than £150
https://www.alliedautoonline.com.au/two ... ant~352275
buy these and get em sent buisness courier if in a real hurry
same again below
https://www.plumkrazygarage.com.au/prod ... c-ve-vf-vg
https://shopping.rewardia.com.au/VE_VG_ ... 1214109166
https://www.ebay.com.au/sch/i.html?_fro ... d=1&_sop=7
few options
is your axle orginal??
Dave