Page 1 of 1
Holley Sniper
Posted: Sun Sep 24, 23 8:48 pm
by morgan
Just got back from US and found this in my suitcase ! Result ! Appears to be the new 'sniper2' with dizzy and coil and loom and automatic timing blah blah blah. I'm not a purist.
Guess my winter project is sorted then...
It'll be a slow burn thread but I will keep it updated
Re: Holley Sniper
Posted: Mon Sep 25, 23 9:31 am
by Dave999
Nice
get it on there
Dave
Re: Holley Sniper
Posted: Mon Sep 25, 23 1:35 pm
by MattH
Contemplating this as well, so I am keen to see how you get on.
Re: Holley Sniper
Posted: Tue Sep 26, 23 12:09 pm
by mr m
Got it on the mustang 347 stroker runs sweet, when wiring in lots of the wiring needs to be cut and shut to keep it tidy or just tie wrap it up and hide the excess, also if you run a e/fan you can wire it in and set it via ecu programme
Re: Holley Sniper
Posted: Wed Sep 27, 23 2:54 pm
by morgan
I was just going to go the sniper route - but decided that I might as well have it do the timing as well - so I got the dizzy and the electronics which will play nice with the injection. Mt current timing is fixed due to lack of vacuum so this should play nicer.
We'll see. There are a LOT of boxes...
Will have a 12V MSD all-in-one setup for sale at the end... get rid of that ballast resistor folks !